ETIC 2230 Guía de usuario descargar pdf (Pagina 45)

OPERATION

XSLAN shdsl switch User’s guide ref 9014709-01 Page 45

1 SHDSL link operation and troubleshooting

We summarize hereafter the different steps to carry-out to bring an shdsl

link into service.

1.1 Configure the products

?? Assign an IP address to each XSLAN switch

See IP protocol & routing IP protocol menu

Configure the SHDSL interfaces of each XSLAN switch

?? Configure the SHDSL port

See “Ethernet & switching” / “SHDSL port” menu

Port 1: LTU or NTU

An LTU interface must be

connected to an NTU interface.

Data rate = Select the auto option or a data rate in accordance with the

distance (see appendix 1).

Note : If the “auto” option is selected, it will cause the XSLAN to try all the

data rates. The connection delay will be longer. Moreover, the XSLAN

software will select a cautious solution. It is why the “auto” option will be

selected only if the distance is short (less than, 1 Km).

Don’t forget to SAVE each page and to REBOOT when the configuration

is carried out (click the red button “Reboot”).

1.2 Connect the line

Wire 1 and 2 of each line can be inverted.

Check the cable shield is connected to the earth.

Note : For test purposes before installation a straight RJ45 cable can be

used to simulate a line.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 53 54

Sin comentarios

ETIC 2230 Guía de usuario Pagina 45